top of page
EVERYTHING YOU NEED TO KNOW ABOUT YOUR MASKS:
- Assembly and disassembly
- Maintenance
- Settings
- replacement of parts
The NEXT mask was developed to meet the demands of extreme sports, in multiple ways, including part replacement!
Through your multiple stunts or your desires for renewal, you will be able to change everything about your masks.
We will show you how everything can be disassembled and replaced on a NEXT mask.
Mounting / Dismounting your screen:
Disassembly
To remove your screen, open the two side triggers, place a finger under the screen to push it vertically, then slightly spread the mask to disengage the lower anchor point of the screen, lift the screen to disengage the two upper points of the screen.
Screen mounting
Start with the bottom middle point, position and press, position the top two points and press.
Close each trigger at least 1 to 2 times to re-center the screen.
This operation can be done without putting your fingers on your screen which remains clean!
Outrigger Frame Replacement:
After dismantling your ramps, pull simultaneously on the foam frame and the outrigger frame to separate them.
Replace with a new frame in the color of your choice by doing the operation in reverse order.
Clipping may be a little hard, check that all the anchor points are correctly positioned.
FIND A DEALER
FRAME OUTRIGGER
Available in 7 colors
FOAME FRAME
Available in 9 colors
Assembly and disassembly of the headband:
To remove your headband, form a U and slide the headband into the slot in the mask.
Reverse the operation for reassembly.
Be careful to position the seam of the headband correctly on the inside of your mask, for support and aesthetic reasons!
Your headband is slipping!
We have a solution with the STOP STRAP kit, two small pieces that will immobilize your headband
FIND A DEALER
Trigger adjustment:
Your screen is too hard to open or conversely, it is too flexible and could open by itself!
You can solve your problem in a fraction of a second.
Take a Torx T8 screwdriver and slightly unscrew the two trigger screws:
- to harden the opening push the triggers on the outside of the mask, - to soften the opening push the triggers on the inside of the mask
Tighten the screws in the position of your choice
Mounting an MX screen:
Position the screen starting with the two side anchors in the Ramps, then the bottom middle and finishing with the two top points of the mask.
bottom of page